HOW TO: MAKE A CAN PIPE

DIRECTIONS FOR MAKING A CAN PIPE

Stoner Score: 1 out of 5 pot leaves!

STEP 1: MATERIALS

Only two items are necessary to build a can pipe; a can and a sharp/pointed object.

STEP 2: CRUSH IT

Turn the can so that the opening is toward the ground. Then push in the top of the can to create a dent that will eventually keep the weed from rolling off the can.

STEP 3: POKE IT

Poke a few small holes in the center of the dent you created. These holes will become the “screen” of your pipe. Make sure not to make the holes too big or else the weed will be sucked into the can.

STEP 4: CARB IT

Make a round hole in the side of the can. The hole should be small enough to be covered easily by your thumb while smoking.

STEP 5: SPARK IT

Place the weed onto the screen of your can pipe. While holding the carb with your thumb, light the weed and suck through the opening of the can. When you feel that your lungs are getting full of smoke, release the carb.

STEP 6: TRASH IT

Dispose of the evidence.

BUD SAYS: This technique is best left for emergencies only as some studies have linked aluminum to memory disorders.

Share